After a Flash Flood on Pimmit Run: Cleaning Up a McLean Lower Level
On July 8, 2019, more than four inches of rain fell on McLean in a day, much of it in about an hour. This guide uses what happened that morning to lay out what to do before, during and after the next flash flood.
Last updated
This guide is for McLean homeowners whose lower level took on water in a flash flood, or who want to be ready for the next one. It starts with what happened on July 8, 2019, explains why McLean's streams rise so fast, and then walks through the cleanup hour by hour. When you need a cleanup crew, see the contact page for how to reach the referral line.
What happened on July 8, 2019
A cluster of slow-moving thunderstorms settled over the Washington area during the morning rush hour. Reagan National Airport recorded 3.3 inches of rain in one hour, close to a month's worth. At 10:08 a.m. the National Weather Service's Sterling office described the situation as a Flash Flood Emergency for the District, Arlington, Fairfax County and Alexandria, a rare step reserved for severe threats to life and property.
In McLean, the river forecast center's 24-hour total was 4.17 inches, third-highest on its list behind two Montgomery County, Maryland locations. Pimmit Run rose over its banks at the McLean Little League fields. The Fairfax County Park Authority closed the west parking lot at Scotts Run and a bridge at Lewinsville Park. VDOT kept Kirby Road at Pimmit Run and Swinks Mill Road by Scotts Run closed for months, noted that Pimmit Run would have to be realigned to its original course, and reported damage to a sanitary sewer line and other underground utilities.
Inside houses, the water came the way it usually does in McLean: over window well sills, under walk-out doors, through floor drains, and in some cases through foundation walls. Most of it arrived within an hour or two.
Why McLean's streams rise so fast
Pimmit Run drains about 8,083 acres, from headwaters west of the Capital Beltway along Gallows Road, through McLean, to the Potomac. Fairfax County's Middle Potomac watershed plan, which also covers Scotts Run, Dead Run, Turkey Run and Bull Neck Run, notes that before 1972 the county did not require new development to reduce stormwater quantity. Neighborhoods built before then send their runoff to the streams through pipes and channels with little holding capacity. When rain falls at several inches an hour, the system fills almost immediately.
The county has been working on this for years. Projects in the Pimmit Run watershed include a neighborhood stormwater improvement project in Kent Gardens, aimed at reducing structural, yard and road flooding, and stream restorations along Little Pimmit Run. Those projects help, but no drainage system is designed for every storm.
Storm water in the lower level right now? Start with safety, then extraction.
Referral phone lineLaunching soonBefore the next storm
- Clear window wells after the leaves drop and check the drain at the bottom.
- Test the sump pump by pouring a bucket of water into the pit, and consider battery backup.
- Extend downspouts well away from the foundation and keep gutters clear.
- Shelve basement storage so boxes are off the floor.
- Find your main shut-off and your electrical panel, and label the basement circuits.
- Read your policy for flood coverage and the water and sewer backup endorsement; see the Virginia claims guide.
- Look up your flood zone on the FEMA Flood Map Service Center, remembering that flash floods reach unmapped areas too.
During the storm
- Stay out of moving water outside; a few inches can knock a person down and roads near streams flood fast.
- Do not go into a basement with standing water if electrical outlets, a furnace or appliances are in the water. Switch off the circuits at the panel if you can reach it safely from a dry floor.
- If a floor drain is backing up, stop using water anywhere in the house.
- Take photos and video as the water rises; they help with any claim.
The first day after
- Make it safe. Power off to the wet area, and keep children and pets out because storm water is contaminated.
- Document. Wide photos of each room, the water line on the walls, the entry point and damaged belongings.
- Move belongings. Anything that can be saved goes to a dry floor; contaminated soft items are bagged and listed.
- Call your insurer to open a claim and ask about any coverage that applies.
- Start extraction. Pumps and extraction tools remove the water and mud; see storm and flash flood water cleanup.
The first week
Because storm water is contaminated, carpet and pad it reached are removed, drywall is cut above the water line, and wet insulation comes out. The slab, wall bases and framing are cleaned before drying. Then dehumidifiers and air movers run, usually inside plastic containment, until moisture readings in every material match a dry reference. Block foundation walls are often the last to dry. The finished basement flooding cleanup and structural drying pages go into detail.
If a floor drain backed up during the storm, the same steps apply; see basement flooding from a sewer or drain backup. If anything was left wet too long and growth appears, see mold remediation after water damage.
Report public drainage problems
A blocked culvert, a storm drain that overflows onto your lot or a damaged stream bank belongs to Fairfax County's stormwater program or, for roads, to VDOT. Reporting it helps the county plan projects like the ones already underway in the Pimmit Run watershed.
After cleanup
Many owners rebuild the lower level with materials that tolerate water better, such as tile or vinyl flooring instead of carpet and drywall kept off the slab. Grading, drainage and waterproofing work are separate projects for other contractors and are not part of this cleanup referral.
Storm water in the lower level right now? Start with safety, then extraction.
Referral phone lineLaunching soonQuestions McLean homeowners ask
How much rain fell in McLean on July 8, 2019?
The National Weather Service's Middle Atlantic River Forecast Center listed 4.17 inches in McLean for the 24 hours from the morning of July 8, the third-highest total in its regional list. Across Fairfax County, spotters reported between about 2.2 and 5 inches.
Is my house in a flood zone if it flooded in 2019?
Not necessarily. Flash flooding from overwhelmed drainage can reach houses outside FEMA's mapped flood zones. The FEMA Flood Map Service Center shows the official zone for your address, and Fairfax County's stormwater program can tell you about known drainage problems nearby.
How soon after a flash flood should cleanup start?
As soon as it is safe to enter and the power to the wet area is off. Storm water is contaminated and soaks into carpet, pad and drywall quickly, and the EPA advises drying wet materials within 24 to 48 hours. The first day matters most.
Sources
- NWS Middle Atlantic River Forecast Center – July 8, 2019 flood summary
- NWS Flash Flood Statement, 10:08 AM EDT July 8, 2019 (IEM archive)
- Northeast Regional Climate Center (NOAA) – July 8, 2019 rainfall
- Patch – Flooding damage closes parts of Fairfax County parks, roads
- Patch – Flooding damage keeps McLean roads closed for months (VDOT)
- Fairfax County – Middle Potomac Watersheds Management Plan, Pimmit Run chapter
- Fairfax County – Middle Potomac Watersheds Management Plan, chapter 3
- Fairfax County – Kent Gardens neighborhood stormwater improvement project
- U.S. EPA – mold, moisture and your home (brief guide)
- FEMA Flood Map Service Center